|
|
|
|
|
|
|
|
|
|
bigal doctor
Joined: 17 Apr 2007 Posts: 352 Location: TEXAS |
Posted: Wed Jun 20, 2018 6:05 pm Post subject: KIP 860 Belt error |
|
|
Got a e-0722 error , belt skewed right. After removing front cover you can see the trans belt is about 1/4 inch from right edge of drive roller and about 1 inch from left side of drive roller.
Any one know how to move belt over without taking out belt assy?
made run it in service?? But I don't want to damage edge of belt if it is already too close to right edge. ( as viewed from front operator position.) |
|
|
|
|
|
|
|
|
|
|
doodad medical school grad
Joined: 03 Mar 2008 Posts: 72
|
Posted: Thu Jun 21, 2018 12:04 pm Post subject: |
|
|
Check the level of the machine. If it is off, level it again. If it is level, raise the side it is skewed toward and run the belt motor routine. Be very careful it does not run any farther than it has. |
|
|
|
|
|
|
|
|
|
|
KipCody medical school grad
Joined: 16 Jul 2013 Posts: 65 Location: Knoxville, TN |
Posted: Fri Jun 22, 2018 10:21 am Post subject: |
|
|
I know they have a tech tip out for the 900's for this same issue. It's TIP-K140-011. But like doodad said, definitely check level first. If you haven't done it recently might also want make sure that you're level is calibrated. |
|
|
|
|
|
|
|
|
|
|
eboucher resident
Joined: 27 May 2008 Posts: 197 Location: Nashua, NH |
Posted: Tue Jun 26, 2018 4:06 pm Post subject: |
|
|
Toner build up on the sensor. Get a can of compressed air and blow it off. It may look like it drifted but It's more likely that there is toner build up. Also then is an updated sensor to replace but it requires removing the belt unit. _________________ I'll have a tech give you a call shortly. |
|
|
|
|
|
|
|
|
|
|
bigal doctor
Joined: 17 Apr 2007 Posts: 352 Location: TEXAS |
Posted: Mon Jul 02, 2018 6:27 pm Post subject: belt sensors kit |
|
|
Do you have the part number or Kip bulletin on it?
Is it for both right and left sensors.
Got the code again today after cleaning it after about 10k feet! |
|
|
|
|
|
|
|
|
|
|
caltech doctor
Joined: 24 Feb 2006 Posts: 262 Location: Northern California |
Posted: Mon Jul 09, 2018 2:32 pm Post subject: |
|
|
Hey Alan, It is TB-K135-025 I have ordered a couple of the kits since they are free but I have not installed one yet. I have a couple of machines that run dirty and get this error often. I tapped 2 air can tubes together to make a long one and just blow off the toner. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|