KeepItPrinting.com

[xerox_7]

I removed the charge corona, and re-strung the 2 charge wires. I cleaned the grid with water. It looked like the center of the grid was lightly rubbing on something. You could see like a lightly polished marking along tyhe center section of the grid and about 6 inches on either side of horizontal center. I put the machine back together and it ran prints yesterday. I did notice a haze buildup on the drum, but did not have time to clean it yesterday. Today, I removed the process unit scrubbed the drum down with alcohol after taking a soft cloth and wiping all of the loose toner from the drum. Now, after re-assembling everything I am at a E51 8 error. I know that the SM says a faulty HV Bias supply, but is there anything I could have put back together wrong. I vacuumed the cleaning roller and have also tried running without the cleaning roller. I have had the developer and process assy out one other time to clean a similar haze from the drum without any problems. Any suggestions?

Thank You
Alan
Triangle Blueprints.

[xerox_7]

Self inflicted injury. Somehow one of the compression springs in one of the electrode holders on the process frame came out. Made one and now it it works.