arlen resident
Joined: 30 Nov 2009 Posts: 157 Location: Salt Lake City, Utah |
Posted: Wed Jun 10, 2015 3:39 pm Post subject: Cut Length Issues between decks 1 & 2 |
|
|
Prints out of roll deck one consistently cut 8mm shorter than the same prints run out of roll deck two.
Leading Registration, Trailing Margin, & Cut Length settings are at default. But those settings control both decks equally.
Swapped
All clutches between both decks
Sensors
Pinch rolls with leaf springs between both decks
Anyone seen anything like this, or have any ideas?
Thanks |
|