|
|
|
|
|
|
|
|
|
|
gregryjb dreaming of medical school
Joined: 11 Apr 2013 Posts: 5
|
Posted: Tue Nov 12, 2013 4:21 pm Post subject: KIP 3100 Printing Blanks |
|
|
I have a 3100 that appears to have a good developer and drum but not putting out an image from scans or prints. Not sure what to think but curious if someone else may have run into this same problem before? |
|
|
|
|
|
|
|
|
|
|
newbe1 doctor
Joined: 20 Aug 2009 Posts: 289 Location: Boise Idaho |
Posted: Tue Nov 12, 2013 5:00 pm Post subject: |
|
|
What i would check is to see if the dev unit is pressed all the way to the drum and also check the tr/seperation unit maybe you have a broken corona wire it could be a bad hvps. |
|
|
|
|
|
|
|
|
|
|
mark in vegas doctor
Joined: 20 Oct 2010 Posts: 1852 Location: Las Vegas, NV |
Posted: Wed Nov 13, 2013 12:15 pm Post subject: |
|
|
Pull a side panel and make sure the printhead is working also.... _________________ Regards,
Mark
RVN 68-69
It's so nice to be insane
No one asks you to explain |
|
|
|
|
|
|
|
|
|
|
bigal doctor
Joined: 17 Apr 2007 Posts: 352 Location: TEXAS |
Posted: Wed Nov 13, 2013 5:09 pm Post subject: Blank Prints |
|
|
Had this on a 3000 recently. The developer drive gear on right side of frame is spring loaded and meshes with developer unit when you open and close clamshell. It was sticking down and not meshing with developer drive so developer unit was not turning. A little spray lube freed it up. |
|
|
|
|
|
|
|
|
|
|
bigal doctor
Joined: 17 Apr 2007 Posts: 352 Location: TEXAS |
Posted: Wed Nov 13, 2013 5:10 pm Post subject: Blank prints |
|
|
SORRY I MEANT TO SAY LEFT SIDE OF FRAME! |
|
|
|
|
|
|
|
|
|
|
tjohnson doctor
Joined: 23 Aug 2010 Posts: 508 Location: Idaho Falls, Idaho |
Posted: Wed Nov 13, 2013 7:17 pm Post subject: |
|
|
There is a setscrew in that developer drive that can work its way out and become loose also. If you turned the machine off half way through a print or copy job, look at the drum for any image toner on it, if there is none you have a developer drive problem, if there is toner on the drum but still have blank prints then check into the transfer corona wire assy. |
|
|
|
|
|
|
|
|
|
|
dlee doctor
Joined: 07 Nov 2006 Posts: 1459 Location: E. Syracuse NY |
Posted: Thu Nov 14, 2013 2:27 pm Post subject: |
|
|
I can remember this happening to me on 3 different KIP3000s and each time it was because of the DC motor that turns the cams that pushes the Dev. Unit forward, went bad. Part number is 9000380072, if you want to go that route. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|