 |
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
 |
KeepItPrinting.com
The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
buildingex
dreaming of medical school
Joined: 09 Sep 2013
Posts: 1
|
 Posted: Mon Sep 09, 2013 9:56 am Post subject: Blank or all black bottom sections of prints |
  |
|
We have a KIP 5000 that will leave a lower section of the plan either completely blank, or on occasion print a solid block of toner. We've had our service guy out multiple times to try to fix it, but he's had no luck so far. It only happens to about a quarter of what we print, and then there are some days where it works just fine.
Any help or advice would be greatly appreciated, as you can imagine reprinting a quarter of jobs can get pretty expensive. |
|
| |
|
|
|
|
|
|
|
|
snap off
dreaming of medical school
Joined: 30 Jul 2008
Posts: 9
Location: somewhere over the rainbow
|
| Posted: Thu Nov 07, 2013 5:46 pm Post subject: |
|
|
I'm not sure but i think your hard disk drive could be the culprit,i remember that it happen to me 6 or 7 years ago .
Change the hard disk and i was back in business.
Sorry for the delay but i don't come here often.
Good Luck |
|
| |
|
|
|
|
|
|
|
|
cezwhat
resident
Joined: 24 Aug 2005
Posts: 221
Location: On the Prairie
|
| Posted: Thu Nov 07, 2013 6:09 pm Post subject: |
|
|
| Sounds like corona wire issues to me. If the wires have been replaced I would look to the end blocks on the transfer sep unit. beyond that it might be the HVPS. |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
