 |
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
 |
KeepItPrinting.com
The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
Nathan_Snapper
doctor
Joined: 08 Oct 2008
Posts: 274
|
 Posted: Tue Jan 01, 2013 7:50 pm Post subject: NotEnough Buckle in the paper and paper being pulled tight |
  |
|
When i print anyothing to the 6000 it has no buckle in the paper when coming up from the drawer. Now KIP said it was the drawers clutches but already replaced those. I also have done the following.
replaced clutches
replaced paper feed motor
replaced side clutches
replaced cutter
adjusted the main motor speed
adjusted the paper motor speed
adjusted the fuser moror speed
and nothing different happens. I get one page that cuts right. but then after that they all pull too tight and cuts it crooked and tears in the cuttter. Any suggestions? |
|
| |
|
|
|
|
|
|
|
|
tjohnson
doctor
Joined: 23 Aug 2010
Posts: 508
Location: Idaho Falls, Idaho
|
| Posted: Thu Jan 03, 2013 1:25 pm Post subject: |
|
|
| When you say you replaced the side clutches, I am assuming they are the second clutches that drive the feed from each drawer? Does it have this problem on all sizes from all drawers? Have you replaced the registration clutch since that is the only clutch that all the paper rolls use? I would also check that the registration sensor is working properly and the gate sensor. |
|
| |
|
|
|
|
|
|
|
|
cezwhat
resident
Joined: 24 Aug 2005
Posts: 221
Location: On the Prairie
|
| Posted: Tue Jan 08, 2013 2:39 pm Post subject: |
|
|
| It was the reg clutch |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
