|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
tech2tech doctor
Joined: 04 Mar 2005 Posts: 377
|
Posted: Thu Apr 06, 2006 12:10 am Post subject: 3000 trailing haze |
|
|
I have been noticing that all the 3000 I have come across have a haze on the trailing edge. Wanted to see if their is a fix for this. |
|
|
|
|
|
|
|
|
|
|
Neil Johnston doctor
Joined: 23 Dec 2005 Posts: 402 Location: Seattle, WA |
Posted: Thu Apr 06, 2006 3:49 am Post subject: |
|
|
I've seen this happen due to static. Clean the paper path with Brillianize.
Also, I've seen it happen because the Regulation Roller isn't pressed against the Dev Roll well enough. (allowing too much toner onto the drum) When you tighten the Reg Roller brackets (has springs) there is one side that has the gear. Make sure you tighten the brackets without the gear on as noted in the install instructions. Also, the side with the gear has a brass screw you loosen and then tighten back up. Before tightening the brackets down loosen the brass screw... use your thumb and press down on the Reg Roll shaft (where the gear will soon go) As you hold a solid pressure down on the Reg shaft tighten the brass screw. Then tighten both spring brackets. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|