|
|
|
|
|
|
|
|
|
|
Jammin intern
Joined: 04 Sep 2007 Posts: 121 Location: Colorado |
Posted: Tue May 22, 2012 3:38 pm Post subject: AC Controller board no light |
|
|
The light on the AC controller board is not lit and I am having a hard time figuring out why the controller will not turn on with the machine.
If the light is not on that is probably a good indication the board is bad...huh? |
|
|
|
|
|
|
|
|
|
|
dlee doctor
Joined: 07 Nov 2006 Posts: 1459 Location: E. Syracuse NY |
Posted: Tue May 22, 2012 3:51 pm Post subject: |
|
|
Conect a power cable directly from a wall outlet to the controller and start it. Most likely this will power on the controller. If it does come on, it's most likely the fuse on the board. Check it first, I usually put a meter on it at both ends to see if there is continuity. The fuse is usually white coated and you won't be able to see if the connecting element inside is blown. You can find a replacement at any Radio Shack or electronics component store and you can use the clear fuses.... |
|
|
|
|
|
|
|
|
|
|
Jammin intern
Joined: 04 Sep 2007 Posts: 121 Location: Colorado |
Posted: Tue May 22, 2012 4:23 pm Post subject: |
|
|
The power cable does work, replaced fuses just in case. still no powere to the controller. |
|
|
|
|
|
|
|
|
|
|
dlee doctor
Joined: 07 Nov 2006 Posts: 1459 Location: E. Syracuse NY |
Posted: Tue May 22, 2012 4:42 pm Post subject: |
|
|
So the power cable from wall DOES work but replacing the fuse did not help..hmmm. Just in case you meant to say that it DOES NOT work, I would replace the power supply. |
|
|
|
|
|
|
|
|
|
|
Jammin intern
Joined: 04 Sep 2007 Posts: 121 Location: Colorado |
Posted: Tue May 22, 2012 6:17 pm Post subject: |
|
|
The power from the wall DOES work, the power cable from the machine DOES NOT work. I replaced the fuses to try and get the power from the machine to WORK. I Should have said "still no power to controller when plugged into the machines powers cable." Power Supply is fine, Just dont know what board it could be AC power, UPS board on controller or roll feed board. Dont have the money to get all three and try them all. |
|
|
|
|
|
|
|
|
|
|
mark in vegas doctor
Joined: 20 Oct 2010 Posts: 1852 Location: Las Vegas, NV |
Posted: Tue May 22, 2012 8:05 pm Post subject: |
|
|
Do you have the wiring diagrams? If not PM me with your email. You should be able to follow the power cord back to where it's connected and with your meter find the problem. _________________ Regards,
Mark
RVN 68-69
It's so nice to be insane
No one asks you to explain |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|