 |
|
|
|
|
|
|
|
|
|
Jammin
intern
Joined: 04 Sep 2007
Posts: 121
Location: Colorado
|
 Posted: Thu May 17, 2012 6:00 pm Post subject: Controller power Board.. |
  |
|
| Was wondering if anyone could tell me what board it is on the 2000 that turns the power off and on the the controller. My controller will not power on unless i hook up outside power source. |
|
| |
|
|
|
|
|
|
|
|
arlen
resident
Joined: 30 Nov 2009
Posts: 157
Location: Salt Lake City, Utah
|
| Posted: Fri May 18, 2012 11:06 am Post subject: |
|
|
| Looks like it comes off of the roll feeder board J235 pin 16. According to my diagram the roll feeder board is located just below fuser exit and slightly left of center facing the rear of the machine. Good Luck |
|
| |
|
|
|
|
|
|
|
|
CHILLIN
doctor
Joined: 05 Oct 2006
Posts: 950
|
| Posted: Fri May 18, 2012 12:08 pm Post subject: |
|
|
| If I recall properly it's to the left of of the controller. Should have a fuse on it. Check the voltage on the plug one white wire and one black wire. Also check the fuse it might be blown. If the board ends if being bad PM if you need a board I have a few around. |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
