|
|
|
|
|
|
|
|
|
|
RMS intern
Joined: 05 Sep 2006 Posts: 111
|
Posted: Tue Jul 03, 2007 6:01 pm Post subject: 3002 Small Deletion At End |
|
|
I have a 3002 in the field with approximately 113k and at the end of a 30"x42" I am getting a deletion in the print. The machine has new wires and the developer has been rebuilt. This problem just showed up and it does not matter what I change it is always in the same spot at the end of the print and only at the end. All other print sizes are ok. For some reason I think I am missing something. Have any of you come across this???? Thanks in advance. |
|
|
|
|
|
|
|
|
|
|
peter_kelowna medical school grad
Joined: 28 Nov 2006 Posts: 78
|
Posted: Mon Jul 09, 2007 6:36 pm Post subject: you can check... |
|
|
go into the service screen and ensure "Expanded Margins" in on.
You can also turn on "Transfer Support" here.
Or go into Service Mode - #4 Adjustments. Try adjusting "Transfer Corona Off Timing" (submode 2)
or "Trail Margin" (submode 2 or 3) Two submodes here to adjust for roll and cut sheet seperately.
I have also found that the KIP driver can sometimes cause funky print results, but that's for a different show. |
|
|
|
|
|
|
|
|
|
|
CHILLIN doctor
Joined: 05 Oct 2006 Posts: 950
|
Posted: Mon Jul 09, 2007 11:46 pm Post subject: |
|
|
Look to see if the paper is laying down flat as it goes across the T&S assy on the longer prints. I have seen the 3000 if the fuser section is too tight or the fuser speed is off a bit cause a slight wave in the paper as it enters the fuser section not enough to cause a wrinkle in the paper, but enough of a wave as to not transfer the image in the middle of the print on the trail edge usually only on longer prints 30x42 or 36x48. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|