|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
Charlie Brown doctor
Joined: 09 Aug 2005 Posts: 434 Location: Nashville Tennessee |
Posted: Thu Dec 28, 2006 9:29 am Post subject: Fuser Drive Gear |
|
|
I have a kip 3000 that has in a month time gone thought two fuser drive gears, this unit falls past the Mod kit ser # and I was told by kip that they are coming out with mod kit for this range of numbers. This unit has the oil lite bearing. The last gear it broke it spilt it in haft and this time bent the drive pin on the shaft. Has any one else see this. I check the fuser unit it run fine not tight. And after I replace the pin and gear ran fine. Also try finding a 2x14 mm pin. |
|
|
|
|
|
|
|
|
|
|
GR81 doctor
Joined: 09 Sep 2005 Posts: 431 Location: MN |
Posted: Thu Dec 28, 2006 2:49 pm Post subject: |
|
|
I have a 300 that is doing the same thing. I did notice that when the fuser almost stops, it will reverse. I talked with tech support and we suspect the dc driver board is causing this. I have replaced 3 gears in 2 monthes. Next visit I will try the board. |
|
|
|
|
|
|
|
|
|
|
MonsenTech medical school freshman
Joined: 10 Aug 2005 Posts: 25
|
Posted: Tue Dec 04, 2007 11:41 am Post subject: |
|
|
I had a 3000 that did something really weird right out of the box. The machine ran fine, but the fuser ran BACKWARDS. Everything else absolutely spot on, but the fuser running backward. After replacing everything from the DC controller to the fuser motor, the resolution to the problem was a bad firmware chip revision. They're supposed to be backward compatible, but I doubt it. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|