|
|
|
|
|
|
|
|
|
|
Tinyminime medical school grad
Joined: 08 May 2007 Posts: 69 Location: Auckland NZ |
Posted: Thu Apr 03, 2008 9:12 pm Post subject: The wonderful Kip1880----yay it is dropining its roll |
|
|
Hi guys.... i have a naughty 1880 that keeps randomly dropping the roll out as the copy process is starting. This is a real pain fault , when a tech arrives it works well most times but two hours later the customer phones and the problem is back, when the problem is there is stays and as by magic it works again for days not missing a beat. We have had the machine in our work shop for two weeks and have rebuilt it to try to get to the source of this problem. It has had all paper path sensors , clutches replaced. We have swapped out all boards and trans sep units etc. We thought we fixed it because it worked for one week but when we moved it to put the back cover on the same problem returned.
The problem is as follows.....
paper always loads correctly and sits in the correct position.
feed your original in and the roll paper feeds the correct direction
within 3 to 4 inches then the roll stops and feeds backwards
the original continues to feed through and the machine indicates it is out of paper. _________________ I used to have hair!!! |
|
|
|
|
|
|
|
|
|
|
KIPDOCTOR Site Admin
Joined: 31 Dec 1969 Posts: 1408 Location: Boston Area |
Posted: Fri Apr 04, 2008 6:53 pm Post subject: |
|
|
Seen it. You need to replace both of the primary paper feed rollers. Very common. _________________ What we have gained in technology, we have lost in humanity. |
|
|
|
|
|
|
|
|
|
|
Chazbo doctor
Joined: 05 Jul 2005 Posts: 377
|
Posted: Sat Apr 05, 2008 11:30 am Post subject: |
|
|
Take black electrical tape and wrap two layers of tape around the black rubber infeed roller. Do this on both ends of the roller. _________________ Ride To Live |
|
|
|
|
|
|
|
|
|
|
Tinyminime medical school grad
Joined: 08 May 2007 Posts: 69 Location: Auckland NZ |
Posted: Sun Apr 06, 2008 4:29 pm Post subject: wonderful 1880 |
|
|
Thanks guys, i forgot to mention i have fitted brand new feed rollers and have fitted the wonderful tape mod to the feed roller. This seems to happen after the the paper is feeding through it thinks it has run out of paper, so it drives the roll back. It seems so intermittent but when it happens it stays faulty ongoing then it magically disappears and runs well for a week.
I have had three techs look at this machine and they all have lost hair over it too? Any more suggestions? _________________ I used to have hair!!! |
|
|
|
|
|
|
|
|
|
|
DCP00 medical school senior
Joined: 14 Feb 2008 Posts: 31 Location: Outside USA |
Posted: Mon Apr 07, 2008 3:11 pm Post subject: |
|
|
The first thing I do when have this problem I remove the two pulleys on the left and right of the in feed roller (where you load the roll) they are the white ones held on with grubb screws. You will notice on the 1900 they are removed. Hope this helps. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|