|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
lhendrix medical school freshman
Joined: 28 Mar 2007 Posts: 17 Location: Alpharetta, GA |
Posted: Wed Sep 19, 2007 9:24 am Post subject: 7000 voltage leak? |
|
|
Prints (internal or external) almost blank in the center and weak on both edges with squiggly lines down print like a dirty charge wire. I swear it looks like I have a corona/grid arcing but I can't track it down. I've replaced charge corona assembly, drum, charge corona block on frame, high voltage power supply, interface board, trans/sep corona assembly and process unit basket. Even threw in a new developer unit for good measure with no difference in copy quality. Should I just completely gut this machine down to the frame and start over? Any ideas guys? DESPERATE!!! _________________ I used to be indecisive...but now I'm not so sure |
|
|
|
|
|
|
|
|
|
|
BigRedTruck medical school grad
Joined: 08 Aug 2007 Posts: 93 Location: So Cal |
Posted: Fri Sep 21, 2007 9:45 am Post subject: Have you tried replacing the paper? |
|
|
Have you tried replacing the paper? Or the Drum end caps? |
|
|
|
|
|
|
|
|
|
|
scott doctor
Joined: 06 Dec 2004 Posts: 570
|
Posted: Fri Sep 21, 2007 11:56 am Post subject: |
|
|
Is the image on the drum correctly, or is it not getting off the drum?
Scott |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|