|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
bigal doctor
Joined: 17 Apr 2007 Posts: 352 Location: TEXAS |
Posted: Thu Feb 04, 2021 7:44 pm Post subject: Won't print on roll |
|
|
Hard to explain and appears randomly ,Maybe occurring after roll runs out..So customer sends a job and it says to load 30 inch roll
BUT screen shows it is loaded. Back out roll and refeed after its done but it won't allow you to confirm its been loaded. Yellow band over roll 2 on touchscreen.
Butif you unload both rolls and swap positions ie put 36 in back and 30 in front, it will load and work fine!
Its done this a few times so recently updated System K software and firmware but just did it again.
I believe it occurs when they run out of paper on roll2.
Reboot had no effect on it. It will only work if you swap both rolls! |
|
|
|
|
|
|
|
|
|
|
caltech doctor
Joined: 24 Feb 2006 Posts: 262 Location: Northern California |
Posted: Sat Feb 06, 2021 3:42 pm Post subject: |
|
|
Hey Al, This is a known bug in the software. An easier way around it is to select some other size roll, like a metric size, click OK. Then go back in and select the correct size and hit OK. This works for me every time. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|