|
|
|
|
|
|
|
|
|
|
SHORTROUND resident
Joined: 23 Mar 2005 Posts: 155
|
Posted: Fri Jul 12, 2019 9:08 pm Post subject: J-0107 |
|
|
i have a Kip 7100 and is giving a Jam J-0107 jam in separation. Paper bunches up at the fuser but does not make it in. I can run several prints before it jams. I have replaced the fuser exit sensor as the book says but with no luck. Sensor changes state in service mode |
|
|
|
|
|
|
|
|
|
|
jedi4342 medical school grad
Joined: 27 Aug 2014 Posts: 64
|
Posted: Mon Jul 15, 2019 10:28 am Post subject: |
|
|
What about the PAPER EXIT sensor. It has the encoder wheel on it. Had 1 that would keep messing with me. Turned out to be that sensor. Run some then jam. |
|
|
|
|
|
|
|
|
|
|
SHORTROUND resident
Joined: 23 Mar 2005 Posts: 155
|
Posted: Wed Jul 17, 2019 10:22 am Post subject: found it |
|
|
Found the problem. The right front brass bushing on the transport belt unit would seize up sometimes and cause the belts to stop driving. It had actually worn into the shaft |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|