|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
james resident
Joined: 10 Dec 2005 Posts: 249 Location: So Calif |
Posted: Tue Dec 11, 2018 12:44 pm Post subject: |
|
|
Cobra,
The xerox manual's elec bsd's are much better than Kips. I can email the manual to you but need your email address.
james |
|
|
|
|
|
|
|
|
|
|
Cobra medical school senior
Joined: 11 May 2006 Posts: 46
|
Posted: Fri Dec 14, 2018 12:22 am Post subject: |
|
|
Replaced the board and was able to get 4 individual prints to print. I upped the count to 2 copies of the same page and it began with the same exact problem again. Now it won't even print a single sheet without stopping. I'm open to any and all suggestions. |
|
|
|
|
|
|
|
|
|
|
CHILLIN doctor
Joined: 05 Oct 2006 Posts: 950
|
Posted: Fri Dec 14, 2018 11:33 am Post subject: |
|
|
Just curious if you have tried running the machine without the auto stacker to see how it prints?
Have you tried masking the E-07 error code and tried to print something?
Have you actually replace the exit (reed sensor) and the magnet on the actuator arm? I have seen these be very flaky in the past and actually have had to replace the magnet a few times.
Last have you tried telling the customer it time to upgrade to a new machine? kidding somewhat. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|