|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
OCJenks medical school freshman
Joined: 22 Oct 2014 Posts: 12
|
Posted: Wed Jan 24, 2018 12:25 pm Post subject: 7100 J-106 even after sensors replaced |
|
|
Originally this customer had an issue with the paper jamming just before the fuser. Swapped TR/SP unit in case that was the cause.
I changed the separation sensor with one I had in stock, but it still jammed.
I ordered a new sensor in case the one I had was also bad, installed new sensor and started machine up, but it said offline and would not read the rolls or meter.
I ended up pulling the fuser again and found that the wires for the connector for the separation area were bad.
I took a connector from a diff. machine and butt spliced it to the wires of the machine that has the problem and then put it together and started it up.
All fine, no errors, printer online, all looks good, so I send a test print and it goes through fine, so I have them send a job and first page jams in the center again.
It seemed like it was catching in the center so I adjusted the thermostat up a bit and printed a whole job with no errors.
Got an email today that it is jamming again This happens with 30 inch paper and 24 goes through fine. (Did not test 36)
What am I missing?! |
|
|
|
|
|
|
|
|
|
|
slyman doctor
Joined: 23 Apr 2008 Posts: 467 Location: Sherbrooke,Quebec |
Posted: Fri May 25, 2018 2:59 pm Post subject: |
|
|
With the right cover removed, can you see if the paper stick on the transport section ? Is the sensor is actived correctly ?
I also already found that by vibration, the rear door switch is not actived within a second a stop the machine and cause a jam.
Do you have any resistance from the 30inch roll ? You wrote that the 24inch work fine, what happen if you switch rolls ?
I'll let you know if I got others ideas. |
|
|
|
|
|
|
|
|
|
|
dlee doctor
Joined: 07 Nov 2006 Posts: 1459 Location: E. Syracuse NY |
Posted: Tue May 29, 2018 11:26 am Post subject: |
|
|
The section that is behind the fuser and has the transport belts on them, you had to remove it to replace sensor. Make sure it is sitting flush and the front tabs are in the slots. I've seen this before and it will cause random jams. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|