 |
|
|
|
|
|
|
|
|
|
KipCody
medical school grad
Joined: 16 Jul 2013
Posts: 65
Location: Knoxville, TN
|
 Posted: Wed Jul 13, 2016 9:13 am Post subject: Fuser Jam |
  |
|
| I've got a 940 that gets a consistent jam at the fuser. I've rebuilt the fuser recently in a hope to help alleviate the issue to no help. It's almost as if it's getting caught in the fuser web. Just wanted to throw it up here and see if anybody as any ideas. Thanks! |
|
| |
|
|
|
|
|
|
|
|
scott
doctor
Joined: 06 Dec 2004
Posts: 570
|
| Posted: Wed Jul 13, 2016 2:14 pm Post subject: |
|
|
Don't know if it will help, but check the fuser tension sensor. The fuser entrance plate has to have some movement. I had the tension sensor giving me the correct reading but the plate itself did not move at all. Play with the mounting bracket for the sensor and make sure the plate can move a bit while still getting the reading you need from the sensor. It caused fuser jams, not quite what you describe, but close.
_________________
Any ideas expressed are figments of my imagination.
Any resemblance to reality is purely coincidental. |
|
| |
|
|
|
|
|
|
|
|
KipCody
medical school grad
Joined: 16 Jul 2013
Posts: 65
Location: Knoxville, TN
|
| Posted: Thu Jul 14, 2016 8:58 am Post subject: |
|
|
| I had actually talked to another tech that gave me the same advice. I fiddled with it a bit and so far it seems to be working fine. Thanks for the tip! |
|
| |
|
|
|
|
|
|
|
|
maggoolee2525
medical school grad
Joined: 21 Dec 2015
Posts: 85
|
| Posted: Thu Oct 12, 2017 11:08 am Post subject: kip 940 |
|
|
| hey guys ..just about to pick up a kip 940 with system K software on board ...noticed the fuser problem as well as the charge wire concerns ....is there anything else i would expect on having this used unit sea freight shipped to me...could someone guide me on the basic removal and cleanup when it arrives ...with the fiery image Pro and laptop |
|
| |
|
|
|
|
|
|
|
|
KipCody
medical school grad
Joined: 16 Jul 2013
Posts: 65
Location: Knoxville, TN
|
| Posted: Thu Oct 12, 2017 11:13 am Post subject: |
|
|
| I actually wound up chasing my jam issue down to the gear on the fuser motor. It was worn down just enough that the timing was getting thrown off. Replaced it and haven't really had an issues with it since. |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
