|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
awtech medical school grad
Joined: 06 May 2008 Posts: 99
|
Posted: Wed Jan 14, 2015 3:44 pm Post subject: 7900 lead edge void on first print |
|
|
I have a 7900 that will make a lead edge void usually in the center of the lead edge on first print after it has been sitting for a while. The second print will be fine. After it sits idle a couple of minutes, the first print will have a lead edge lack of transfer void. I am assuming it has to do with transfer because, you will see the missing material down the page about a drum diameter or so. |
|
|
|
|
|
|
|
|
|
|
tjohnson doctor
Joined: 23 Aug 2010 Posts: 508 Location: Idaho Falls, Idaho |
Posted: Wed Jan 14, 2015 4:32 pm Post subject: |
|
|
Have you adjusted the transfer on timing to see if that makes any difference? |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|