 |
|
|
|
|
|
|
|
|
|
phan6622
doctor
Joined: 09 Feb 2007
Posts: 750
Location: Midwest
|
 Posted: Thu Nov 13, 2014 3:58 pm Post subject: Not accepting roll #2 |
  |
|
I have a KIP 5000 that is not taking roller #2, it keeps kicking it out. I've swapped spindles, replaced the clutches, switched out the paper end clock sensor with the sensor from roll 1, replaced paper roll set sensor PH1B. The machine still is rolling back the roll of paper. What would you recommend doing next?
I'm really thinking this is a sensor causing this issue, but I can't pin-point which one! |
|
| |
|
|
|
|
|
|
|
|
phan6622
doctor
Joined: 09 Feb 2007
Posts: 750
Location: Midwest
|
| Posted: Mon Nov 24, 2014 4:34 pm Post subject: |
|
|
| we now changed out the 1 way gear.. still no solution to the problem. |
|
| |
|
|
|
|
|
|
|
|
tjohnson
doctor
Joined: 23 Aug 2010
Posts: 508
Location: Idaho Falls, Idaho
|
| Posted: Tue Dec 02, 2014 4:01 pm Post subject: |
|
|
| I had the same problem i fought for several hours, exchanging the clutches between rolls fixed my problem, it is possible you just swapped clutches around but maybe the clutch used has the same problem? I know these clutches tend to overdrive when they get old and that creates issues with sensors. |
|
| |
|
|
|
|
|
|
|
|
phan6622
doctor
Joined: 09 Feb 2007
Posts: 750
Location: Midwest
|
| Posted: Wed Dec 10, 2014 1:19 pm Post subject: |
|
|
We had already swapped the clutches.
Problem was the bushings around the pulse disk shaft were plugged up with grime causing the pulse disk to not spin via friction drive.
Last edited by phan6622 on Thu Dec 11, 2014 1:47 pm; edited 1 time in total |
|
| |
|
|
|
|
|
|
|
|
tjohnson
doctor
Joined: 23 Aug 2010
Posts: 508
Location: Idaho Falls, Idaho
|
| Posted: Wed Dec 10, 2014 1:34 pm Post subject: |
|
|
| Thanks for providing an update and solution! |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
