 |
|
|
|
|
|
|
|
|
|
MackD
medical school grad
Joined: 14 Aug 2007
Posts: 89
|
 Posted: Wed Oct 15, 2014 10:06 am Post subject: Canon |
  |
|
Have a IPF755 that keeps dumping/replenishing the ink tanks into the maintenannce cartridge. Replaced the mainboard, carriage, purge unit and printhead.
I have followed the procedure for all items replaced including the new printhead procedure going into service mode to clear errors without printhead installed etc. Any would be appreciated.
Thanks |
|
| |
|
|
|
|
|
|
|
|
Placebo
intern
Joined: 06 Dec 2012
Posts: 139
|
| Posted: Wed Oct 15, 2014 11:29 am Post subject: |
|
|
| Check for air in the ink tubes. If no air then replace the head management sensor. Also make sure they are using the correct magenta ink. The 755 takes a unique magenta ink for some dumbass reason. I've seen people snip out the plastic tabs to make a PFI-102M ink cartridge fit but the 755 requires PFI-104M. Are you getting any error codes? |
|
| |
|
|
|
|
|
|
|
|
MackD
medical school grad
Joined: 14 Aug 2007
Posts: 89
|
| Posted: Wed Oct 15, 2014 11:45 am Post subject: |
|
|
Yes the error on the control panel is E161-4050 but it not in the service manaual for some reason. And in service mode it just has a 038... to replace the ink cartridges nothing solid to go on.
Thanks!! |
|
| |
|
|
|
|
|
|
|
|
MackD
medical school grad
Joined: 14 Aug 2007
Posts: 89
|
| Posted: Wed Oct 15, 2014 11:46 am Post subject: |
|
|
| And the ink tubes do not have air, there is all ink. |
|
| |
|
|
|
|
|
|
|
|
Placebo
intern
Joined: 06 Dec 2012
Posts: 139
|
| Posted: Wed Oct 15, 2014 12:11 pm Post subject: |
|
|
| Yeah there are only 2 E161 errors listed in the manual and both refer to the print head. So if you've already replaced the print head then I would consider the head management sensor, trailing cable, and/or carriage assy. |
|
| |
|
|
|
|
|
|
|
|
Placebo
intern
Joined: 06 Dec 2012
Posts: 139
|
| Posted: Fri Oct 17, 2014 11:50 am Post subject: |
|
|
| What are the odd's? I hit that same error yesterday after replacing a main board on a 755. Called Canon and they said it is related to the head management sensor. Then he asked me to print a nozzle test and as soon as I tried loading paper I got a 03130031-2F14 which is error writing to ASIC, replace main board. New main board purchased from Canon last week and it's bad out of the box. I had a feeling something like that might happen as the new board had that burnt electronics smell to it when I opened it up. |
|
| |
|
|
|
|
|
|
|
|
GR81
doctor
Joined: 09 Sep 2005
Posts: 431
Location: MN
|
| Posted: Wed Oct 22, 2014 1:14 pm Post subject: |
|
|
| Also if you are using non OEM inks you can get this error. |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
