|
Home of the Kip Doctor!
REGISTER: In order to register for our forums please send an E mail to [email protected] stating what user name and password you would like. This is now required due to all the spambots that have been registering.
|
KeepItPrinting.com The "unofficial' and "unauthorized" KIP info site.
|
|
|
|
|
|
|
|
|
|
|
kapman dreaming of medical school
Joined: 04 Jan 2014 Posts: 1
|
|
|
|
|
|
|
|
|
|
|
cjwilt doctor
Joined: 24 Jan 2007 Posts: 1041
|
Posted: Thu Jan 09, 2014 5:01 pm Post subject: |
|
|
This looks like it's coming from the developer assy. Check to see if toner is getting past the regulation roller. |
|
|
|
|
|
|
|
|
|
|
Bill intern
Joined: 14 Dec 2004 Posts: 104 Location: Canada |
Posted: Wed May 07, 2014 7:38 pm Post subject: |
|
|
Did this problem get resolved and was it double imaging ?
Bill |
|
|
|
|
|
|
|
|
|
|
dlee doctor
Joined: 07 Nov 2006 Posts: 1459 Location: E. Syracuse NY |
Posted: Thu May 08, 2014 9:43 am Post subject: |
|
|
Looks like it could be a broken gear on the dev. unit. causing one of the rollers (either regulation roller or dev. roller) to bounce around.
OR
Not likely, but it could be fuser related too.
Take both side covers off and run prints. If you look through the side, you'll be able to see the prints come out from under the drum, going into the fuser. If you can catch it just right, do a hard stop right when the LE of the paper is out of the drum area and right before it goes into the fuser. This will eliminate the fuser section as a culprit. Do you hear any clumping or grinding in the dev. unit area? Check all of the plastic gears. If you have a dev. unit spin tool, take the dev. unit out of the printer and turn the rollers. There could be a gear with a hairline fracture that you might not be able to see except under heavy load, it might separate a little bit but enough to cause an issue. |
|
|
|
|
|
|
|
|
|
|
eboucher resident
Joined: 27 May 2008 Posts: 197 Location: Nashua, NH |
Posted: Mon May 12, 2014 10:22 am Post subject: |
|
|
You could try to re-pressurize the dev unit. Remove the regulation gear on the left side and re tighten springs? _________________ I'll have a tech give you a call shortly. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|
|
|