 |
|
|
|
|
|
|
|
|
|
dogdreamshhi
medical school freshman
Joined: 28 Feb 2008
Posts: 13
Location: Hilton Head Island
|
 Posted: Wed May 12, 2010 2:03 pm Post subject: Still printing light in the middle |
  |
|
| Had developer rebuilt, prints look great except after about 12 prints the next three are real light in the center and then go back to looking perfect again. Any ideas? |
|
| |
|
|
|
|
|
|
|
|
phan6622
doctor
Joined: 09 Feb 2007
Posts: 750
Location: Midwest
|
| Posted: Wed May 12, 2010 4:42 pm Post subject: |
|
|
| When they get light, do you see any ghosting? (reprinting of the light image further down the page) just wondering if the problem is in fusing? Doesn't really make sense but your problem doesn't really make sense anyways. You sure that that dev unit is good? Do you have one to swap for checking? Check the drum ground and dev connections I guess.. could be an incosistent connection... use tiny amounts of conductive grease. |
|
| |
|
|
|
|
|
|
|
|
dogdreamshhi
medical school freshman
Joined: 28 Feb 2008
Posts: 13
Location: Hilton Head Island
|
| Posted: Wed May 12, 2010 4:48 pm Post subject: |
|
|
Nevermind
Cleaned the led and it seems to be printing fine  |
|
| |
|
|
|
|
|
|
|
|
phan6622
doctor
Joined: 09 Feb 2007
Posts: 750
Location: Midwest
|
| Posted: Wed May 12, 2010 4:58 pm Post subject: |
|
|
| should have been bad on all prints? or maybe just the prints that had thinner lines? |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
