KeepItPrinting.com

the problem is the customer use 2 roll of 24 inch and only print format 18’’x24’’ , when the roll #1 finish and switch to roll # 2 you have a white copy about 36’’ inch long or more never ...

Hello I have probleme with 3100 machine, the problem is too dark on the left side (facing of the printer), the machine have 90k sq ft, i replace the maintenance kit a (developer), i ajust the charge, ...

Hello,

I have problem with the kip 8000 printer, I have two machine side to side (one is more worse) first have 13.5 million sq feet and the other have 16 million sq feet, the problem is wit ...

I have the same issue with 2 machines... Sad

Check tech bulletin (TIP-K103ips-001 Toner Dumping) or your pressure on the side of dev.

Hello,

i have problem with 7000 machine, the problem is wrinkle any time on each roll 24'' or 34'', i install new firmware user mode ud=on and switch dehumidifier=off, i install Roll Deck A ...

Finaly i change the drawer to solve the problem, i dont know for what reason probably a wire ?

Thanks for your help.

Pat.

I had this happen a couple of months ago. Is drawer 2 doing it as well? In my case, drawer 1 was backing out and drawer 2 was jamming. Turned out there was a piece of paper in the cutter. I cleaned ...

I have problem with kip 2001, the problem is paper roll 1 unloading intermittent, I replace ph1 (paper set sensor), both clutch, brake, I ajust brake and I check all screw is tight, I replace ph2a (p ...

the problem is ( an error occurred (6) ) intermittent, i replaced the white-roller and the original glass assy, I check In service mode in section ccd adjustment to make marker on and I have red light ...

I have problem with led head, i cleaned led head with glass cleaner i replace the pad, the motor and lubricate the worm gear shaft. I have always dirty on led on right side after 2 days. The machine h ...

Hello,
i have problem with trim sheet, jam in the middle of the machine, i block hole each side to have more suction in centre but not success, in the unattend.ini you can ajust min cut len ...

I have new machine kip 5000 with 40 030 sq/f and I have problem of sliver of media ½ inch in cutter section about 10 times a day sometime jam with the cutter and have e-040 and sometime no error code ...

I have problem sometime, intermittent with 33.11'' is creasing on all page for couple of days and for no reason the problem disapear, the same problem in 6000,7000,8000 machine. Thanks for your help .

Do you found something to solve that ? Do you think the corona block tr/sp can be the cause ? Or do you have any idea ? i have the same problem, i change developer kit, drum and fuser and i have the s ...