KeepItPrinting.com

Ok guys, bad news here. The LB12 sensor (crossfold section) seem not stable. I found when I put small pressure on transport guide where the LB12 sensor is attached, the siganl goes on/off. Sometime I ...

Just a quick feedback..it's fix ! It was the LB12 sensor in the crossfold section.

After replacing the sensor, i did make more than a 100 prints with no jam.

I don't remember the jam code Arlen. I have ordered some sensors and will give a try.

Yeah I do have some minor help, I will order some sensors to start with. I do have to confirm the firmware but I'm pretty sure I already installed the latest last year.

There is not really great in ...

Ok guys, an old Kip fold on 7170 (non-K), got intermittent jam in the crossfold section.

The sheet come in the crossfold section, the first gate move to guide the paper but does not move up to it's ...

Is anyone already see a double feed problem on KIP 7000 IPS(or not) ??

Roll 3 and 4 both feed in same time !

If you have any idea. Thanks

Hi guys, first, I already spoke to one of kc3 support tech but I ask here if someone have another idea, I take everything.

We install a working used Kip Fold 2000 on a Kip 7170 IPS, the folder itse ...

You can try to remove 1 or 2 turn of pressure on the pressure roller and add some high temp oil in the pressure roller bearings. Those are problematic for that kind of noise.

That problem appear si ...

Tell your tech to raise the corona height by 1 or 2 mm from the bottom of the transfer unit, it helped sometimes.

Hey guys, if it's cold in the south of US, imagine here in Quebec !!! God damn I'm tired of this winter...and it's not finish Crying or Very sad

Yes Kip sent me the color advanced code sheet to scan in the color code
After talking with Kip support some KM machines had advanced color.
He had me run setup again and after entering the mono co ...

With the right cover removed, can you see if the paper stick on the transport section ? Is the sensor is actived correctly ?

I also already found that by vibration, the rear door switch is not acti ...

I never see any Advance color on that machine, always got basic color. Did Kip give you the "arrow" sheet ?? (the one you can scan the code in color advance) Or the "$" key code color ?

Anyway, I'm ...

Yeah it's not the sameas the old 3000/3100's and I think the "new" shape is like that since the 7100's. I never change any fuser drive gears since those machines/models.

Had to replace the whole charge corona ass'y one time but most of it, I replace the grid and that fix that black print or black streaks