KeepItPrinting.com

Thanks!

I think this is a fuser NTC Error?? I dont have my laptop with me so hoping someone sees this and can tell me which one it is. I think far right. Lets see how good my memory is haha.

Error 08509

When I stand at the rear and hold the outer fuser door against the inner door the prints come out fine until I let go. It appears that the outer pressure wheel that rides on the encoder wheel is not m ...

I changed the output to front only in the config settings but the page only comes out about 6 inches of the front output then just halts throwing a J-0210. any ideas? seems like a sensor but i do not ...

Gents,

I have an urgent need for the latest release of firmware for the Oce PW350 model. Is there anyone that can burn me images of these discs and host them remotely for download? I would be most ...

I was able to fix this issue on Friday after talking with Kip tech support. I had to flip dip switch 3 on the data control board and then boot the Machine. This is apparently some sort of initializati ...

Weird that i just found this post.

I have a kip 3000 doing the EXACT same thing. I replaced the lens covers (glass) with new ones and reassembled the scanner and when i booted the printer the USB ...

if anyone can help me with this please send me a PM and i will give you my email address.

THX

It did not deem like I could bend much without damage. The gap is not in blade and blade roller it is in blade roller and dev roller

Hey folks. lets try this one. I have a KIP 2000 that has less than 10k sq/ft on it and has terrible background in center. here is what i have noticed. there is a slight gap between the dev roller and ...

Also for me it has been hit or miss by replacing the caps. I have had some be successful and some were not.

I may have had a similar issue once.

in the kip color software change the prescan to a smaller amount like 2 inches and see if that fixes the problem. this was the only way i could find around the ...

Have you tried booting the controller outside of the machine? Do you get the same result? Just to be sure the video cable is not damaged.

If you do get the same result, this sounds like typical bad ...

Let me say that on the first plotwave 350 we sold, we did not have the toner in stock yet so we gave them 300 toner and they used it with no issues. This was part of the CBT for the PW350 but i cannot ...

Did you clean the black cleaning roller behind the drum with a vacuum? this can cause some backgrounding if the roller is caked with toner. after you sweep that roller clean the drum as well. if you a ...