KeepItPrinting.com

Great info. Thank you very much!

First display was half blue half black. Reset all connections on IPS (the white box) and after a few reboots get this message > The ialmrnt5 display driver has stopped working normally. Save your w ...

Thank you, thank you, thank you!!

I posted my problem with the spindle slipping inside the core's and found from older post there is a mod kit that Charlie said works great! Anyone have info. on this? or part #? Thanks for any reply. ...

they have a gripper mod kit and this kit works grate.

Would you have the part # for this mod, or more info.

thanks very much

Jerry

I was just looking through some old post and one member (Charlie) mentioned there was a gripper mod kit available? Ummmm, anyone know of this?
Thanks

At first I though the rolls were backing out, so adjusted the spindle clutch on the end like I have done several times. Still backing out slipping? I pull out roll again and this time (by accident) I ...

Will look at this tomorrow, but talking with cust. on phone every time they install a new roll it does the cut trim sheet but leaves it in the machine! They dig it out and it happens all over again do ...

Thank you that is a great offer, but I don't think our service manager would fly a tech from Texas. Even our own IT guy is lost! We would consider outsourcing this if it comes to that, anyone closer t ...

I just checked my profile and my e-mail is correct if anyone can help?
Thanks again guys!

We have lost our KIP dealership years ago right after the 2000 came out and my password was also erased, so I can't even access the KIP dealer section > gurrr! Have a cust. now who needs to upgra ...

Wait, lets make sure I got this correctly, are you saying raise the whole T/S unit, the corona wire, or just the chrome plate? ummm, thanks again

Thanks man, will take a look at that.

Prints come out clean but cust. is complaining the back is getting dirty. What? I flip one over and sure enough the trail edge all the way across covering say 18" or so up is just black toner that the ...

Thank you! I had the post "what am I missing" with the 6000 going into sleep during the day. The controller time was off 3 hours and the start and off time were also set during working hours. After re ...