KeepItPrinting.com

There's a small door above the screen that hides the monitor controls. The next time the screen messes up try pushing the "auto" button and if that doesn't work try the "power" button. Shut it off for ...

Thanks for the quick response. I performed a digital exorcism ( ghost the IPS, 485 patch, keycodes, etc.) Reseat the connectors on the control board. It seems to be behaving itself. I'll keep an eye o ...

I know this is an old post. I'm hoping someone has a fix for this. I've got a 3000 s#1051**** thats doing the same thing. It's got 500K miles on it and has gone through it's fair share of clutches, co ...

Have you checked the fuser rollers? The pressure between the rollers could be greater on one end causing the paper to buckle. Also some of the older 3000s have a mylar guide on the tran/sep corona uni ...

Are the cooling fans in the IPS working (power supply & processor)? We've had a few funky power supply issues.

The T/S blocks are shorting out. Replacing the unit will fix the problem. But it will come back again. I've got into the habit of cleaning and checking the condition of the tran/sep wires and blocks a ...

If your going from 08A to 13B eprom you have to change the motor wiring harness - it comes in the trailing edge haze counter measures kit, along with a new tran/sep corona unit & eprom. Without t ...

Correct. The top one drives the deck exit roller and forms the paper loop that allows a straight paper cut. Thats the one I replaced.

Replace the paper feed mag clutch in the paper deck. I had one wrinkling & cutting uneven too. Turned out to be the mag clutch that drives the exit rollers on the paper deck. Those are the rollers ...

I was right. It was the $2500.00 scanner data board. It sure pays to have these suckers under service contract.

I have a fairly new 3000 with some funky scanner problems. After replacing the left most CIS glass. We ran the white balance calibration. Instead of an even slate grey being displayed on my laptop aft ...

Check the fuser roller bearings as well. I had a 5000 with only 77K on it with ghosting on the left side of prints. It was a bad upper fuser roller and lower roller bearings. The upper bearings were'n ...

Can anyone tell me what the monthly volume of a 5000 is. We took over service on a 2 year old 5000 with only 77K sq. ft. on it. I had to replace the upper fuser roller and upper/lower bearings already ...

I had a customer jack up the leveling pads to move the machine 1 foot to the left. They could'nt say why it had to be moved in a nearly empty room. Needless to say, the kip was now way unleveled and h ...

Did you tell them they had a screw loose? Or did they allready know.