KeepItPrinting.com

Try resetting BIAS 3 back to zero.

It's currently at 0

I think it is due for one. There just a bit pricey

http://i.imgur.com/7b1RPVI.jpg
http://i.imgur.com/5G8wgoz.jpg

tried cleaning led's corona wires. to the eye the dev and drum look fine, its not the fuser any ideas? this has 256k on it dev has be ...

If your talking about the admin login on the control panel it's 6428.

web browser and i found it

administrator with no password

customer updated there ERP and it doesnt work is this machine to old for this upgrade is it a driver issue maybe.

thank you

anyone know what the admin password and login is for these? customer lost the ability to print/scan

There both on

Seals look OK Dev itself looks good this only has 3k prints

Hello,
Not sure what the cause this is I have replaced charge corona cleaned transfer corona. Could this be a voltage issue?

http://i168.photobucket.com/albums/u168/JRS161176/_20161207_08423 ...

Hi all

Im having issues with what looks like the fuser binding up, now this is intermittent i can run 100s through and it eventually makes a loud humming sound then jams ( stacker jam) or sometimes ...

I have not are they the same kind of sensor?

Hey all

Issue I'm having is deck 2 isn't seeing any paper loaded at all. The sensor in front of 2 has been replaced the one under deck 1 are there any more sensor that should be replaced that's ca ...

Is there a way to enable the cutsheet option can't find it in the manual. Trying to walk customer through it

Anyone know where this option is located? Can't find anything in the manual

Fixed issue. for anyone having this issue it was the charge wire unit above the drum . the copper ground was not in contact with the led housing.👍